Notice of MG Chemicals Responsibility
Regarding Momentive Performance Materials (formerly GE Silicones) Products
You have requested a Momentive Performance Materials (formerly GE Silicones) page on the MG Chemicals website. Please read and acknowledge this notice. When you click the acknowledgement at the bottom of the page, you will be redirected to the page you requested.
MG Chemicals is an authorized distributor of Momentive Performance Materials RTV Silicone products.
MG Chemicals is not the manufacturer of these products and is therefore NOT responsible for product quality, and for reasons of legal liability, MG Chemicals cannot provide direct technical support for Momentive Performance Materials' Silicone products.
The specifications shown on this website for Momentive Performance Materials RTV Silicone products have been reproduced from Momentive Performance Materials' printed literature to the best of MG's ability; however, these specifications may have been changed since they were added to the website, and errors may have been made transcribing them. These specifications and product selection guides are presented only to provide website readers with enough information to provide a starting point in selecting a product. IN ALL CASES, before deciding whether a particular product is suitable for your application an up to date product spec sheet and application advice should be obtained directly from Momentive Performance Materials (formerly GE Silicones).
Momentive Performance Materials may be reached at 1-800-295-2392 for technical assistance, application review, and product recommendations.
You will be required to view this notice once every website session in which you visit a Momentive Performance Materials page on the MG Chemicals website.
|RTV60-1P||RTV60 001-Kit (1.0LBS-0.454KG)|
|RTV60-1G||RTV60 012-Pail Kit (12.1LBS-5.477KG)|
|RTV60 requires a primer. Visit our primer guide for details.|
|Use||Potting & Encapsulating|
|Special Feature||High Temperature|
|GE Silicone National Stock Number|
|Pot Life||2 hours|
|Cure Through Time||24 hours|
|Useful Temp. Range||-54°C to 260°C (-65°F to 500°F)|
|Cured Properties - MECHANICAL|
|Hardness||57 (Shore A)|
|Tensile Strength||6.86 MPa (990 psi)|
|Cured Properties - ELECTRICAL|
|Volume Resistivity||4.4 x 1014 ohm ? cm|
|Dielectric Strength||17.7 kV/mm (450 V/mil)|
|Dielectric Constant||4.0 @ 1000Hz|
|Cured Properties - THERMAL|
|Thermal Conductivity||0.31 W/m ? ?K|
|Thermal Expansion||20 x 10-5 cm/cm ?C (11 x 10-5 in/in ?F)|
|Minimum Viscosity||25,000 cps|
|Maximum Viscosity||55,000 cps|
|Mix ratio (by weight)||100:0.5|